Description
Tam Valley Depot DCC No-Buzz In-Line Servo Quieter
Sometimes a servo will buzz or chatter continuously. Some poeple find this very annoying. The No-Buzz goes in line with the servo cord and quiets the servo. Here is how it works - if the servo is stopped in the same position for more than about a second the circuit turns off the servo. If the servo starts moving again it will turn it on and drive the servo until it stops again. When the servo is stopped the gears will hold most switches in place. If you use the SwitchWright geometry then the wire acts as a over-the-center spring and also holds the points while the servo is off. A side benefit of the No-Buzz is that you do not need to adjust the servo as precisely but can overdrive the position and let the servo relax back after it turns off.
How to install In-line Reverser and No-Buzz
Install the units as in the picture to the left. The white wires on both sides go to the side marked S (for signal - on some servos this wire is yellow). The right side with the pins go to the servo and the left side with the female plug goes to the board. You can plug the unit directly in to the board or use a servo extension.
Additional Resources
MANUFACTURERS WEBSITE: |
|
SOUND CONFIGURATION & SOUND FILE RESOURCES: |
|
FIRMWARE & SOFTWARE RESOURCES: |
|
PRODUCT MANUALS & TECHNICAL DOCUMENT RESOURCES: |
|
MANUFACTURERS WARRANTY & REPAIRS: |
|
ADDITIONAL INFORMATION - DCC TIPS: |
|
ADDITIONAL INFORMATION (1): |
|
ADDITIONAL INFORMATION (2): |
Additional Information
PRODUCT CLASS : |
All Scales |
SIZE-INCH (L x W x H): |
0 x 0 x 0 in |
SIZE-METRIC (L x W x H): |
0 x 0 x 0 mm |
ADDITIONAL FEATURES: |
NA |
NOTES (1): |
NA |
NOTES (2): |
NA |