Bulk Order

NCE DCC UTP Cab Bus Facia PanelThis is our lowest cost, easiest to use, cab bus panel. All four RJ-12 jacks are wired in parallel for easy plug and play use. This board also provides a convenient point to add additional 12 Volt cab bus power for long...

NCE DCC UTP-CAT5 Cab Bus Facia Panel     Same six-wire connectors in front as standard UTP but allows use of off-the-shelf CAT5 cables to connect panel-to-panel at rear. Can be used as a cab bus splitter and also adds the ability to add power...

NCE DCC WWLEDx20 3mm Warm White LED (20 pk)   Warm white LED, 3mm, qty 20.  

NixTrainz Decoder Buddy Adapter Board - Test Module     Decoder Buddy V5 and V5B The Decoder Buddy V5 and V5B were developed for the 12 output decoders and include a couple added features. This mother board does not include the 21-Pin Decoder...

OpSIG Publications - A Compendium Of Model Railroad Operations - From Design To Implementation     Dispatcher to OpSIG Publication No. 2, you're... Ready to Roll!     All model railroaders, whether expert or beginner, will find a...

PRE-OWNED unit.  less than one hour on-time.  Was installed on show demo layout that never went to a show...

These are new units.  The were opened and then returned after customer discovered I shipped the wrong product.  One unit of the five total has a broken mounting lug from the extra handling...

RR-CirKits 3TK2-1 I/O Module Mounting Track - Single Position This plastic mounting track is suitable for mounting a single I/O module to a flat surface. (3 1/2" x 2") (I/O board not included)  

RR-CirKits 3TK2-2 I/O Module Mounting Track - Dual Position This plastic mounting track is suitable for mounting two I/O modules to a flat surface. (3 1/2" x 4") (I/O board not included)  

RR-CirKits 3TK2-2W I/O Module Mounting Track - Dual Position Wide Spacing This plastic mounting track is suitable for mounting two I/O modules to a flat surface with extra wiring space between modules. (3 1/2" x 5") (I/O board not included)  

RR-CirKits 3TK2-3 I/O Module Mounting Track - Thee Position This plastic mounting track is suitable for mounting three I/O modules to a flat surface. (3 1/2" x 6") (I/O board not included)  

RR-CirKits 3TK2-3W I/O Module Mounting Track - Three Position Wide Spacing This plastic mounting track is suitable for mounting three I/O modules to a flat surface with extra wiring space between modules. (3 1/2" x 8") (I/O board not included)  

RR-CirKits 3TK2-4 I/O Module Mounting Track - Quad Position This plastic mounting track is suitable for mounting four I/O modules to a flat surface. (3 1/2" x 8") (I/O board not included)  

RR-CirKits 3TK2-4W I/O Module Mounting Track - Quad Position Wide Spacing This plastic mounting track is suitable for mounting four I/O modules to a flat surface with extra wiring space between modules. (3 1/2" x 11") (I/O board not included)  

RR-CirKits 3TK2-6 I/O Module Mounting Track - Hex Position This plastic mounting track is suitable for mounting six I/O modules to a flat surface. (3 1/2" x 12") (I/O board not included)  

RR-CirKits BOB-S Screw Terminal Break Out Board This board is designed to break out the 10 pin IDC ribbon cables into minature screw terminals for easy connections. (0.4" wide by 2.5" long).