LocoNet Command Bus Management Modules

Digitrax BXP88 LocoNet Occupancy Detector with Transponding and Power Management - 8 Detection Sections   BXP88 makes adding detection and transponding to your layout easier than ever.  No more complicated wiring! DCC Occupancy Detection...

Digitrax BXPA1 LocoNet DCC Auto-Reverser with Detection, Transponding and Power Management   The BXPA1 is a combination DCC Auto-Revereser, occupancy detector, Transponding detector, and intelligent power manager. It is designed to make transponding...

Digitrax LNRP-XTRA Digitrax LocoNet Repeater Module w/ PS14 Power Supply   The LNRP Xtra LocoNet Repeater Module Isolates and Protects LocoNet Layouts, it allows for greater expansion of the LocoNet system on large installations.  If a wiring...

Digitrax LNWI LocoNet WiFi Interface Module   The LNWI allows you to connect compatible WiFi devices to LocoNet and run trains using compatible throttle apps. The apps available can be downloaded from this page. Wi-Fi interface to a Digitrax...

Digitrax LT1 Tester for Decoders & LocoNet Cables   It consists of a harness with 6 conductor Telco type wire with a male plug, a tester with a female 6 conductor jack, and a 100 Ohm 2 watt protection resistor. LT1 Features: Use as a...

Digitrax LT5 Tester Module (2pk) for BDL16 Series Boards, BD4N, and other products   2 LT5 Tester Modules For use with BDL16 Series Boards, BD4N, and other products  

Digitrax LT5C Tester Module (2pk) for BDL716, BDL16 Series Boards, BD4N, and other products   2 LT5C Tester Modules For use with BDL716, BDL16 Series Boards, BD4N, and other products  

Digitrax PR4 USB to LocoNet Interface with SoundFX Decoder Programmer The PR4 makes decoder programming and interfacing your layout and computer easier than ever. The PR4 seamlessly switches between computer interface and decoder programming modes...

Digitrax PS14 AC/DC Adapter 300ma 14VDC Power Supply   AC/DC Adapter 14V DC 300ma The PS14 is a 300ma, 14 Volt power supply for powering Digitrax accessories like the UP5, BDL168, DS64, SE8C, LNRP, UR90, UR91 UR92 and others  Universal AC...

Digitrax UP6Z LocoNet Universal Panel and 3 Amp Z Scale Voltage Reducer Features: 6 LocoNet Jacks for use with all scales Reduces track voltage by 4 or 6 volts at 3 amps for safer Z Scale locomotive opreration with Digitrax equipment Digitrax...

Digitrax UP7 LocoNet Universal Interconnect Panel   Plug and Play Universal fascia panel supporting LocoNet. Two RJ12 front panel Throttle jacks. Three RJ12 rear pass-through LocoNet jacks Supports throttle charging. Fully connectorized...

Digitrax UR90X LocoNet IR Infrared Receiver Front Panel Cost effective wireless operation with infrared technology UR90X is a front panel unit that is an infrared receiver.  All current production Digitrax throttles are factory equipped with...

Digitrax UR93 Duplex Radio Transceiver   UR93 Features: Digitrax Duplex Radio Transceiver on LocoNet wire infrastructure (no IR support). More than double the radio range of UR92 Duplex units. Improved multi-path performance for cluttered layouts...

RR-CirKits LCC-LocoNet Gateway LCC (Layout Command and Control) 1024 function LCC – LocoNet translator LCC-LocoNet Gateway Message level gateway connects the LCC ® CAN bus and the Digitrax LocoNet. Dual RJ45 connectors for LCC ® CAN bus...

RR-CirKits LocoBuffer-NG (Next Generation) Digitrax LocoNet® to USB type-A* Interface unit. 1,500 Volt Digital isolation between LocoNet and USB port. Type A* USB connector for direct computer connection. RJ12 connector for LocoNet connection. 3...

RR-CirKits TC Mark II Tower Controller Mark II The TC-64 Tower Controller 64 line LocoNet® interface provides a simple and easy way to connect between the Digitrax LocoNet® bus and the layout. It may be connected at any convenient point on the...