Bulk Order

RR-CirKits LCC Buffer-USB NMRA CAN bus LCC® to USB interface. 2,500 Volt Digital isolation between CAN bus LCC® a

RR-CirKits LCC Power-Point LCC Power-Point ties together 2 LCC jacks, a Traffic Monitor, and a power supply. Create a powered LCC bus for simple wiring by powering your LCC Nodes over the cable. The...

RR-CirKits LCC Repeater LCC Repeater features: Bit level repeater connects two LCC ® CAN bus segments.

RR-CirKits LCC Starter Kit Introductory price for a LCC Buffer-USB, a Power-Point, 2 Terminators, includes 1' LCC cable and USB cable.

RR-CirKits LCC Terminator Pair NMRA CAN bus LCC® Termination Pair. May be used to provide the required termination at each end of the CAN bus LCC® Balanced CAN termination provides the best noise...

RR-CirKits LCC VampMeter LCC Voltmeter and Ammeter features: Easily measure your CAN bus power.

RR-CirKits LCC-LocoNet Gateway LCC (Layout Command and Control) 1024 function LCC – LocoNet translator LCC-LocoNet Gateway M

RR-CirKits LocoBuffer-NG (Next Generation) Digitrax LocoNet® to USB type-A* Interface unit. 1,500 Volt Digital isolation between LocoNet and USB port. Type A* USB connector for direct computer...

RR-CirKits OI-IB-8 8-line Input Opto-Isolation Board This board is normally used for block detection on three rail layouts. This version of the board includes internal current limiters. Useful...

RR-CirKits PS-S-15-1500 AC/DC Adapter 1500ma 15VDC Power Supply This high quality regulated switching power adapter powers any 15 Volt DC device up to 1.5 Amp. Made with quality in mind, this unit...

RR-CirKits RB-2 Dual Relay Board Relay Board - 2 is a Dual 10A DPDT relay board with logic level drivers. It is suitable for use with TC Mark II, TowerMan, Tower LCC, or other logic level output...

RR-CirKits RB-4 Quad Relay Board Relay Board - 4 is a Quad 10A SPDT relay board with logic level drivers. It is suitable for use with TC Mark II, TowerMan, Tower LCC, or other logic level output...

RR-CirKits SDB-4 4-Output Searchlight Driver Board This 4 output board is specifically designed to directly drive 4 four aspect signals utilizing bi-polar or three wire LED's and includes a yellow...

RR-CirKits SHD-2 8-Output Dual Signal Head Driver Board This 8 output signal head driver is a DCC accessory decoder. Includes prototypical lamp fade, brightness adjustment. Built in resistors allow...

RR-CirKits Signal LCC-32H Signal LCC-32H LCC (Layout Command and Control 8 line Input Output board Plus 32 Head controller with special effects

RR-CirKits Signal LCC-P Signal LCC-P LCC (Layout Command and Control 8 line Input Output board Plus 16 LED Driver with special effects