Digitrax

Digitrax LT5C Tester Module (2pk) for BDL716, BDL16 Series Boards, BD4N, and other products   2 LT5C Tester Modules For use with BDL716, BDL16 Series Boards, BD4N, and other products  

Digitrax PS14 AC/DC Adapter 300ma 14VDC Power Supply   AC/DC Adapter 14V DC 300ma The PS14 is a 300ma, 14 Volt power supply for powering Digitrax accessories like the UP5, BDL168, DS64, SE8C,...

Digitrax LT5 Tester Module (2pk) for BDL16 Series Boards, BD4N, and other products   2 LT5 Tester Modules For use with BDL16 Series Boards, BD4N, and other products  

Digitrax LT1 Tester for Decoders & LocoNet Cables   It consists of a harness with 6 conductor Telco type wire with a male plug, a tester with a female 6 conductor jack, and a 100 Ohm 2...

Digitrax DCC DSXSV9 9G Turnout Motion Control Servo for DS78V   The DSXSV9 9G Turnout or Motion Control Servo comes with mounting bracket and installation hardware.  It is simple to...

Digitrax DCC DSXCP1 Fascia Mount Switch Control Device for the DS74   The DSXCP1 is simple way to add point-of-use interface to control switches on your DS74. Features Fascia mount Switch...

Digitrax DSXC4 Input Interconnect Board for DS74   The DSXC4 is simple to install, wire or plug in, and begin using to control switches on your DS74. Features Input interconnect board for DS74...

Digitrax DS78V Stationary Servo Decoder - Eight Servo LocoNet & Accessory decoder for turnout control   The DS78V Stationary Decoder allows you to install and operate your turnouts directly...

Digitrax DS74 Quad Switch Stationary Decoder   The DS74 Stationary Decoder allows you to install and operate your turnouts directly through any DCC system that has turnout control. From Solenoid...

Digitrax DS52 Dual Stationary Decoder for Snap Switches or Slow Motion Machines   Dual Stationary Decoder for Bi-polar, Snap Switches or Slow Motion Machines DS52 Features: Simple hook up and...

Digitrax DS51K1 Stationary Decoder For Single Kato Unitrack Turnouts   DS51K1 Stationary Decoder For Single Kato Unitrack Turnouts, easy cost effective way to add DCC control to your Kato...

Digitrax DS44 Basic Quad Stationary Decoder   Basic Quad Stationary Decoder for Slow Motion Turnout Machines, add cost effective DCC control to your slow motion turnouts. DS44 Features: No...

Digitrax PTBK Pluggable Terminal Block Kit   Pluggable Terminal Blocks Replacement for lost or damaged Pluggable Terminal Blocks For use with products using Pluggable Terminal...

Digitrax CARDEDGE CON 44 3 Pack Edge Connector   3 Pack Edge Connector for use with PM4 Series Boards, BDL16 Series Boards and SE8 Series Boards This is a replacement part that can be ordered...