ESU - Electronic Solutions Ulm

ESU SwitchPilot Extension, Model Number 51801     If required, SwitchPilot can be augmented with the SwitchPilot Extension Modul: Plugged in at the side of the SwitchPilot, it offers four relay-driven outputs, used for switching potential-free...

ESU Precision Servo Motor, Model Number 51804   The Precision Servo Motor is a high-performance and noiseless actuator, introduced by ESU, suitable for the SwitchPilot decoders. It uses a highly-developed remote control (RC) technique and is...

ESU Precision Servo Motor - Metal, Model Number 51805   ESU proudly presents a further, newly-developed servo motor for all ambitious model railway fans. The „Precision Servo Motor - Metal“ is preferred by all model railroaders who look...

ESU 51806 Linear Servo Motor   This linear servo in the dimensions 26mm x 22.5mm x 10.8mm is primarily intended for installation in electric locomotives in order to subsequently make the pantographs raised and lowered. The mechanics enable very...

ESU 51808 ABC Brake Section Adapter for SwitchPilot Extension   These adaptor boards greatly simplify set-up and wiring of ABC braking sections. They are simply plugged into the terminals of a SwitchPilot Extension. Every adaptor board can...

ESU 51809 Signal Adapter for SwitchPilot   Our SwitchPilot decoders cannot only control point mechanisms but also daylight signals. Most modern signals are equipped with LEDs. Usually the anode connections of multi-aspect signals are combined in...

ESU Servo Motor Extension Cable, Model Number 51810   With the Servo Extension Cable you are able to lengthen your Precision Servo Motor by up to 75cm.   3-pole J/R plug on socket J/R / Futaba, Length: 75cm    

ESU 51830 SwitchPilot 3 DCC Accessory Decoder   SwitchPilot 3 decoders are optimized for stationary use on your system and can switch conventional double coil switch drives, light signals, magnetic uncouplers, light bulbs or other stationary...

ESU 51831 SwitchPilot 3 Plus DCC Accessory Decoder   SwitchPilot 3 Plus decoders are optimized for stationary use on your system and can switch conventional double coil switch drives, light signals, magnetic uncouplers, light bulbs or other...

ESU 51832 SwitchPilot 3 Servo DCC Accessory Decoder   SwitchPilot 3 servo decoders are optimized for stationary use on your system and can control up to eight RC servo drives. In order to facilitate the rather cumbersome configuration of magnetic...

ESU 53452 LokProgrammer Set You want to listen to the sound spectrum of your favourite loco, or the special sound of that loco around the corner in the yard – on your model railroad? No problem with ESU’s LokProgrammer! One prerequisite: A...